Influence of the cutting parameters on the workpiece temperature during face milling

Nowakowski Lukasz; Skrzyniarz Michal; Miko Edward; Takosoglu Jakub; Blasiak Slawomir; Laski Pawel; Bracha Gabriel; Pietrala Dawid; Zwierzchowski Jaroslaw; Blasiak Malgorzata

doi:10.1051/epjconf/201714302082

EPJ Web of Conferences (Jan 2017)

Influence of the cutting parameters on the workpiece temperature during face milling

Nowakowski Lukasz,
Skrzyniarz Michal,
Miko Edward,
Takosoglu Jakub,
Blasiak Slawomir,
Laski Pawel,
Bracha Gabriel,
Pietrala Dawid,
Zwierzchowski Jaroslaw,
Blasiak Malgorzata

Affiliations

Nowakowski Lukasz: Chair of Mechanical Engineering and Metrology, Kielce University of Technology
Skrzyniarz Michal: Chair of Mechanical Engineering and Metrology, Kielce University of Technology
Miko Edward: Chair of Mechanical Engineering and Metrology, Kielce University of Technology
Takosoglu Jakub: Chair of Mechanical Engineering and Metrology, Kielce University of Technology
Blasiak Slawomir: Chair of Mechanical Engineering and Metrology, Kielce University of Technology
Laski Pawel: Faculty of Mechatronics and Mechanical Engineering, Department of Automation and Robotics, Kielce University of Technology
Bracha Gabriel: Faculty of Mechatronics and Mechanical Engineering, Department of Automation and Robotics, Kielce University of Technology
Pietrala Dawid: Faculty of Mechatronics and Mechanical Engineering, Department of Automation and Robotics, Kielce University of Technology
Zwierzchowski Jaroslaw: Faculty of Mechatronics and Mechanical Engineering, Department of Automation and Robotics, Kielce University of Technology
Blasiak Malgorzata: Department of Mechanics, Kielce University of Technology

DOI: https://doi.org/10.1051/epjconf/201714302082
Journal volume & issue: Vol. 143
p. 02082

Abstract

Read online

This thesis presents the outcome of experimental research of the impact of changes in cutting speed and volume of material processed during a face milling process on the temperature of the processed object made of copper of M1Ez4 class. Measurement of the temperature of the processed object was conducted in six points with K-type thermocouples. The theoretical amount of released heat per unit of time for particular parameters of machining was also calculated.

Published in EPJ Web of Conferences

ISSN: 2100-014X (Online)
Publisher: EDP Sciences
Country of publisher: France
LCC subjects: Science: Physics
Website: http://www.epj-conferences.org/

About the journal