Bimodal grain structure formation and strengthening mechanisms in Mg-Mn-Al-Ca extrusion alloys

Abstract

The effects of small additions of calcium (0.1% and 0.5%11 All compositions in weight percentage.) on the dynamic recrystallization behavior and mechanical properties of as-extruded Mg-1Mn-0.5Al alloys were investigated. Calcium microalloying led to the formation of Al2Ca in as-cast Mg-1Mn-0.5Al-0.1Ca alloy and both Mg2Ca and Al2Ca phases in Mg-1Mn-0.5Al-0.5Ca alloy. The formed Al2Ca particles were fractured during extrusion process and distributed at grain boundary along extrusion direction (ED). The Mg2Ca phase was dynamically precipitated during extrusion process, hindering dislocation movement and reducing dislocation accumulation in low angle grain boundaries (LAGBs) and hindering the transformation of high density of LAGBs into high angle grain boundaries (HAGBs). Therefore, a bimodal structure composed of fine dynamically recrystallized (DRXed) grains and coarse unDRXed regions was formed in Ca-microalloyed Mg-1Mn-0.5Al alloys. The bimodal structure resulted in effective hetero-deformation-induced (HDI) strengthening. Additionally, the fine grains in DRXed regions and the coarse grains in unDRXed regions and the dynamically precipitated Mg2Ca phase significantly enhanced the tensile yield strength from 224 MPa in Mg-1Mn-0.5Al to 335 MPa and 352 MPa in Mg-1Mn-0.5Al-0.1Ca and Mg-1Mn-0.5Al-0.5Ca, respectively. Finally, a yield point phenomenon was observed in as-extruded Mg-1Mn-0.5Al-xCa alloys, more profound with 0.5% Ca addition, which was due to the formation of (101¯2)extension twins in unDRXed regions.

Keywords

• Magnesium alloys
• Extrusion
• Dynamic precipitation
• Dynamic recrystallization
• Bimodal grain structure
• Mechanical properties