Effect of Floating-Plug Drawing Process Parameters on Surface Finish of Inner and Outer Surfaces of AISI 321 Stainless Steel Thin-Walled Tubes

Abstract

This article presents the results of the analysis of changes in the surface topography of AISI 321 (1.4541) thin-walled stainless steel tubes in single-pass Floating-Plug Drawing (FPD) process. Experimental tests were carried out with variable drawing speed (1, 2, 3, 4, 6, and 10 m/min) and different angles of floating plug (11.3°, 13° and 14°). Wisura DSO7010 (Fuchs Oil) lubricant was used in the experiments. Mean roughness Ra and ten point height of irregularities Rz were adopted as surface quality indicators. Roughness parameters were measured independently on the inner and outer surfaces of thin-walled tubes. Analysis of variance was used to analyse the relationship between process parameters (drawing speed and angle of floating plug) and surface roughness of tubes. A decrease in the values of both analyzed roughness parameters was observed as a result of the drawing process. The FPD process significantly improves the inner surface quality of AISI 321 thin-walled stainless steel tubes. The mean roughness value tends to increase with increasing drawing speed, while the angle of the floating-plug has no significant effect on the mean roughness Ra.

Keywords

• analysis of variance
• floating plug
• stainless steel
• surface roughness
• tube drawing