Ultrasonics Sonochemistry (Mar 2021)
The application of flow to an ultrasonic horn system: Phenol degradation and sonoluminescence
Abstract
Sonochemical (SC) processes can be increased with the application of fluid flow due to changes in bubble characteristics. In this work, a novel flow through set-up was applied to an ultrasonic horn system to investigate the effects of flow on the degradation of phenol. KI dosimetry and sonochemiluminescence (SCL) were also analysed, under the same conditions, to provide comparison of degradation to other SC processes. Further, sonoluminescence (SL) in water and different concentrations of potassium iodide (KI) and phenol solutions was studied to determine the effect of flow on processes inside the bubble that result in SL. The degradation of 0.1 mM phenol solutions, KI dosimetry and SL from phenol (0.1, 20 and 60 mM) and KI (0.1, 1 and 2 M) solutions were analysed under flow rates of 0, 24, 228 and 626 mL/min. For an ultrasonic horn system, all flow rates could augment phenol degradation beyond that of the systems without flow. At the lowest applied power, the amount of degradation was significantly increased with flow, becoming greater than degradation observed at the highest power. A strong correlation between phenol degradation and SC processes indicated that degradation followed an oxidative process. SL intensity from water, KI, and phenol solutions could also be increased with flow beyond the no flow system. For water this occurred most readily at higher powers, then for the solutes there was varied behaviour dependent upon the solute concentration. It was theorised that flow may increase the transfer of radical species to solution to enhance SC processes. An increase in SL, with flow, indicates that flow is acting to change the properties of the bubbles and/or the bubble field such that the active bubbles present collapse with greater total intensity.