Is the Number of Appointments for Complete Denture Fabrication Reduced with CAD-CAM? A Literature Review

Abstract

One of the key arguments in favor of digitally produced complete dentures (CDs) is the requirement for less patient visits in comparison to the conventional workflow. However, it is not yet clear if this argument is accurate; nor, if indeed the insertion of the complete dentures is achieved in fewer appointments, how many are required. The purpose of this literature review was to investigate the reported number of required patient visits for the production of digitally fabricated CDs. An electronic search was performed in PubMed/MEDLINE using three groups of keywords: “complete dentures”, “CAD/CAM”, and “Appointments” with their alternative forms. Out of the initial 157 results, 36 articles were automatically selected utilizing exclusion keywords. After consensus between the two examiners, eight articles were finally analyzed and presented in a table. The majority (75%) of the reports came from institutions, and the average number of appointments up to complete denture insertion was 4.1, not always including try-in dentures. In this study, it can be concluded that, with a digital workflow, the insertion appointment is reached in fewer visits than the conventional five-visit procedure which is commonly taught in dental schools.

Keywords

• CAD-CAM
• complete denture
• digital denture
• milling complete dentures
• 3D printed dentures
• try-in dentures