Preparation and characterization of composite-modified PA6 fiber for spectral heating and heat storage applications

Abstract

Composite coating technology was used to prepare a modified polyamide 6 (PA6) polymer material masterbatch with low mutual interference and good spinnability using molybdenum oxide, tungsten trioxide, graphene oxide, etc., as modifiers. Experiment shows that using nanoscale composite-coated modified masterbatches capable of spectral heating and heat storage in the preparation of nylon 6 fiber, adding modified masterbatches with a mass ratio of 6% online, and controlling various process parameters can result in good functionality and usability as well as enable consistent production. Optimal production conditions are achieved by utilizing pre-dried PA6 chips with a moisture content of 420 ppm. The master batch is subjected to drying at a temperature of 95°C for 12 h. During this process, the master batch is introduced at an addition ratio of 6%. Subsequent spinning is conducted at a speed of 4,300 m·min−1 and a temperature of 255°C. Cooling is facilitated by air set at a temperature of 17°C, flowing at a speed of 0.45 m·min−1. In the production line, one roller operates without heating, while the second roller is maintained at a temperature range of 160°C. The stretching process is performed at a ratio of 1.3. To ensure proper lubrication, an oil rate of 1.3% is applied. These meticulously controlled process parameters collectively contribute to the most favorable production status.

Keywords

• spectral heating
• heat storage
• nylon 6 fiber
• preparation and characterization