Инженерные технологии и системы (Mar 2024)

Optimization of Parameters of Adaptive Spray System for Agricultural Sprayer

  • Ivan I. Gureev,
  • Beket N. Nuralin,
  • Murat U. Mukhtarov,
  • Oksana N. Kostyuchenkova

DOI
https://doi.org/10.15507/2658-4123.034.202401.072-087
Journal volume & issue
Vol. 32, no. 1
pp. 72 – 87

Abstract

Read online

Introduction. When growing tall-growth crops (cereal crops in late the phases of development, corn, sunflower, etc.), there are used boom sprayers equipped with twin-fluid spray cones with fixed angles of inclination to the vertical of the spray cones. The working fluid is applied with such sprays are more intensively on the front side of the plant leaves while the intensity of covering the plants from the back side with the working fluid decreases. The development of the spray system will allow improving the quality of crop treatment with boom sprayers. Aim of the Study. The aim of the research is to determine experimentally the algorithm for changing the angles of inclination of a twin-fluid spray cone that provides the same intensity of applying working liquid to the leaves of high-growth plants. Materials and Methods. The research was carried out on a test bench by applying colored water to the front and rear sides of a tall-growth plant model moving at a specified speed. The experiment was carried out according to the method of optimal planning. The difference between the content of droplets on the front and rear sides of the tall-growth plant model was taken as an optimization parameter. Variable factors were the spray cone inclination angles and the operating speed of the sprayer. Results. The algorithm for changing the optimum values of the spray cone inclination angles depending on the sprayer speed was determined based on the equality of the first derivative of the optimization to zero parameter by the value of these angles. Discussion and Conclusion. According to the algorithm, when the sprayer operating speed increases from 1.2 to 3.2 m/s, the optimal angle of inclination to the front spray cone vertical changes linearly from 25 to 21 degrees, and the rear one ‒ from 46.7 to 57 degrees. This algorithm will allow justifying the technical specifications to develop a processor for automatic control of the spray cone inclination angles cones when the sprayer is operating.

Keywords