Neutron irradiation effects on the low cycle thermal fatigue performance of first wall mock-ups

Abstract

For the first wall (FW) of ITER, beryllium will be the plasma facing material and has to sustain high thermal, particle and neutron loads. In order to assess the synergistic effects of thermal and neutron loads in total ten Be-armored FW normal heat flux (NHF) mock-ups were produced consisting of two Be flat tiles each joined via hot isostatic pressing (HIP) to a CuCrZr heat sink and a steel support structure by different manufacturing routes to assess the most promising ones. Five of them were neutron irradiated, two at Centrum Výzkumu Řež in Czech Republic and three in the High Flux Reactor at NRG in the Netherlands. The remaining mock-ups were kept as reference. All flat-tile mock-ups had two Be-tiles and were exposed to cyclic steady state heat loads in the electron beam facilities JUDITH 1 and 2 up to a maximum power density of 3.75 MW/m2, in order to find the damaging threshold. A screening step using 1 MW/m2 was performed after finishing each loading step and after failure for direct comparison and detection of any deterioration caused by the cycling. Despite being still in the early development phase of Be joining, all mock-ups sustained the cycling up to at least 2.75 MW/m2 and clear differences in the performance of irradiated vs. non-irradiated mock-ups were observed.