Transforming silicon slag into high‐capacity anode material for lithium‐ion batteries

Abstract

Abstract The conception of cheaper and greener electrode materials is critical for lithium (Li)‐ion battery manufacturers. In this study, a by‐product of the carbothermic reduction of SiO2 to Si, containing 65 wt% Si, 31 wt% SiC, and 4 wt% C, is evaluated as raw material for the production of high‐capacity anodes for Li‐ion batteries. After 20 h of high‐energy ball milling, C is fully converted to SiC and a micrometric powder (D50 ∼1 μm) is obtained in which submicrometric SiC inclusions are embedded in a nanocrystalline/amorphous Si matrix. This material is able to maintain a capacity >1000 mAh g−1 (>3 mAh cm−2) over 100 cycles. No crystalline Li15Si4 phase is formed upon cycling as shown from the differential dQ/dV curves. The good mechanical resiliency of the electrode is evidenced by monitoring its morphological changes from sequential focused ion beam scanning electron microscopy analyses. However, a progressive and irreversible increase in the electrode mass and thickness is observed over cycling (reaching 125% and 60% after 200 cycles, respectively), which is mainly attributed to the accumulation of solid electrolyte interphase products in the electrode.

Keywords

• high‐energy ball milling
• Li‐ion batteries
• Si slag
• Si‐based anode
• SiC