Experimental investigation on the surface quality of WEDM machined 20MnCr5 steel for gear application

Abstract

This experimental study investigates the Wire-cut Electrical Discharge Machining (WEDM) of 20MnCr5 steel, a low alloy steel grade material which is intended for the production of gears, shafts and other parts which need high surface hardness and wear resistance. WEDM is a crucial manufacturing process for producing gears, shafts, spindles, and various mechanical components. The investigation focuses on three key performance parameters: profile error, material removal rate (MRR), and surface roughness (SR), employing five WEDM parameters—wire feed (W _f ), wire tension (W _t ), servo voltage (SV), discharge arc-off time (T _off ), and arc-on time (T _on ) - by employing the Taguchi L _27 orthogonal array. The study reveals that, in comparison to arc-on time and servo voltage, wire feed rate and tension have a lesser impact. Higher arc-on time and servo voltage result in increased profile error, while reduced wire tension values elevate surface roughness. Recast layer formation has been explored under different WEDM input parameters, revealing its dependence on arc-on time, voltage, wire tension, and feed rate. Higher voltage leads to uneven surfaces with larger globules and deep craters, contributing to a thicker recast layer at higher arc-on time and servo voltage.

Keywords

• 20MnCr5 steel
• WEDM
• servo voltage
• surface roughness
• profile error
• recast layer