Effect of Pore Defects on Very High Cycle Fatigue Behavior of TC21 Titanium Alloy Additively Manufactured by Electron Beam Melting

Abstract

Titanium alloys additively manufactured by electron beam melting (EBM) inevitably obtained some pore defects, which significantly reduced the very high cycle fatigue performance. An ultrasonic fatigue test was carried out on an EBM TC21 titanium alloy with hot isostatic pressing (HIP) and non-HIP treatment, and the effect of pore defects on the very high cycle fatigue (VHCF) behavior were investigated for the EBM TC21 titanium alloy. The results showed that the S-N curve of non-HIP specimens clearly had a tendency to decrease in very high cycle regimes, and HIP treatment significantly improved fatigue properties. Fatigue limits increased from 250 MPa for non-HIP specimens to 430 MPa for HIP ones. Very high cycle fatigue crack mainly initiated from the internal pore for EBM specimens, and a fine granular area (FGA) was observed at the crack initiation site in a very high cycle regime for both non-HIP and HIP specimens. ΔKFGA had a constant trend in the range from 2.7 MPam to 3.5 MPam, corresponding to the threshold stress intensity factor range for stable crack propagation. The effect of pore defects on the very high cycle fatigue limit was investigated based on the Murakami model. Furthermore, a fatigue indicator parameter (FIP) model based on pore defects was established to predict fatigue life for non-HIP and HIP specimens, which agreed with the experimental data.

Keywords

• titanium alloy
• EBM
• VHCF
• HIP
• pore defects