ERGONOMIC ANALYSIS OF A TELEMANIPULATION TECHNIQUE FOR A PYROPROCESS DEMONSTRATION FACILITY

Abstract

In this study, remote handling strategies for a large-scale argon cell facility were considered. The suggested strategies were evaluated by several types of field test. The teleoperation tasks were performed using a developed remote handling system, which enabled traveling over entire cell area using a bridge transport system. Each arm of the system had six DOFs (degrees of freedom), and the bridge transport system had four DOFs. However, despite the dexterous manipulators and redundant monitoring system, many operators, including professionals, experienced difficulties in operating the remote handling system. This was because of the lack of a strategy for handling the installed camera system, and the difficulty in recognizing the gripper pose, which might fall outside the FOV (field of vision) of the system during teleoperation. Hence, in this paper, several considerations for the remote handling tasks performed in the target facility were discussed, and the tasks were analyzed based on ergonomic factors such as the workload. Toward the development of a successful operation strategy, several ergonomic issues, such as active/passive view of the remote handling system, eye/hand alignment, and FOV were considered. Furthermore, using the method for classifying remote handling tasks, several unit tasks were defined and evaluated.

Keywords

• Teleoperation
• Telemanipulator
• Remote Handling System
• Ergonomic Analysis
• Telepresence
• Pyroprocessing