The Digester Modification for Biogas Production from Palm Oil Mill Effluent by Batch System

Abstract

The purpose of this research is to determine the optimum production of biogas produced from the tuncated pyramid-shaped modification digester equipment on sedimentation tank and shaped beams on the tank fermentation batch. Pyramid-shaped sedimentation tank aiming for optimal deposition process, While the fermentation tank with beam-shaped used to produce biogas that is optimal. The raw material used is Palm Oil Mill Effluent. In the early stages of process is carried out the sedimentation in the first digester tank at a flow rate of 6 liters/minute and then observing the time stayed for 24 hours. POME flowed into the second digester tank to run into fermentation process by adding active microbial seed to produce biogas. After fermentation is complete, streamed to third digester tank to experience water treatment stage before being released into the environment. COD content test value obtained after the processing of 100 mg/l, while the BOD value is 30.9 mg/l. The percentage of methane gas obtained from starter concentration of 30%, ie 9.82% mol for fermentation time of 10 days, while the fermentation period of 20 days is 15.8 mol%. The production of methane gas obtained for the optimum fermentation period of 30 days ie 33.19% mol. For days 31 through 40, the production of biogas run into highs and caused due to the substrate in the digester began to run out and most of the substrate has not been fermented.