An Evaluation of the Dielectric Barrier Discharge Treatment on the Mechanical, Structural and Morphological Properties of Carbon Fibers

Abstract

Carbon fibers (CFs) have been widely applied in the manufacture of polymeric composites. The mechanical properties of these composites depend on the adhesion in the matrix/CF interface. Since the CFs have poor adhesion properties, a surface treatment of the CFs becomes necessary. The plasma process used in this work was the dielectric barrier discharge (DBD). The DBD treatment of twill weave carbon fi bers (2×2) was performed during 2.0; 5.0; 7.5 and 10.0 minutes. CF/polypropylene (PP) composites were produced by hot pressing method. The surface morphology, structure and mechanical properties of CFs were characterized by scanning electron microscopy (SEM), atomic force microscopy (AFM), Raman spectroscopy, interlaminar shear test (ILSS) and dynamical mechanical analysis (DMA), respectively. SEM images show great changes on the CF surface after the treatment, AFM results show that the fi ber treated for 2.0 min exhibited the highest roughness and Raman spectra revealed that the carbon fi ber crystalline structure did not change after the treatment. The ILSS and DMA results show an increase of the mechanical strength and no major change in the glass temperature of the composites after the DBD treatment, respectively. Some results were compared to those obtained in our previous study, in which the plain weave fiber (1×1) was evaluated.

Keywords

• Carbon Fiber
• Dielectric Barrier Discharge
• Surface Treatment
• Composites