Effect of Alloying Elements Mg and Cu on the Modification of Eutectic Silicon in Hypoeutectic Al–Si Alloys

Abstract

The modification of eutectic silicon plays a crucial role in enhancing the mechanical properties of hypoeutectic Al–Si alloys. However, there is still limited understanding regarding the factors that affect the modification of eutectic silicon in hypoeutectic Al–Si alloys, particularly in terms of the role played by alloying elements during the modification process. In order to address this gap, this study aimed to investigate the influence of two key alloying elements, Mg and Cu, on the modification effect of Sr. To achieve this, the morphology of eutectic silicon in the as-cast and heat-treated states of Al–7Si alloy, modified with Sr, was examined using scanning electron microscopy (SEM). Different levels of magnesium and copper content were used to analyze their impact on the modification effect of Sr. The results obtained from the analysis revealed that both Mg and Cu significantly weaken the modification effect of strontium on eutectic silicon. Furthermore, it was observed that the degree of deterioration in the modification effect increases progressively with higher alloying element content. Interestingly, increasing the strontium content and adjusting the cooling rate were found to be ineffective in eliminating this weakening effect caused by Mg and Cu. These findings highlight the complex interplay between alloying elements and the modification process of eutectic silicon in hypoeutectic Al–Si alloys. A deeper understanding of these factors is essential for the development of effective strategies to optimize the mechanical properties of such alloys.

Keywords

• hypoeutectic Al–Si alloys
• Mg content
• Cu content
• Sr modification
• the morphology of eutectic silicon