Investigation of hot deformation behavior and three-roll skew rolling process for hollow stepped shaft of Al–Zn–Mg–Cu alloy

Abstract

The increasing demand for high-strength lightweight hollow shafts in transportation highlights the need for advanced fabrication techniques. Al–Zn–Mg–Cu alloys, noted for their superior properties, are selected for three-roll skew rolling (TRSR). In TRSR, the material undergoes combined axial tensile and radial compressive stresses. This study evaluates the feasibility of TRSR for producing high-strength lightweight hollow stepped shafts from Al–Zn–Mg–Cu alloy. An integrated approach, including constitutive modeling, hot processing map development, and TRSR numerical simulations/experiments, is employed to optimize the TRSR forming process. The constitutive model was established based on 300°C–450 °C & 0.01–10 s−1 hot compression and 350°C–430 °C & 0.1–5 s−1 high-temperature tensile test data. The established Johnson-Cook optimization by genetic algorithms (GA-JC) model and unified viscoplastic constitutive model, accurately capture the alloy's hot deformation behavior, exhibiting minimal average absolute relative errors (AARE) of 5.431% and 5.808%, respectively. Microstructure evolution analyses shed light on the predominant softening mechanisms, emphasizing dynamic recovery (DRV) at elevated strain rates and diminishing texture intensity with escalating deformation temperatures. The composite hot processing map delineates optimal process parameters (400°C–450 °C & 0.1s−1-1s−1), facilitating informed decision-making in manufacturing practices. The validation of numerical simulations through TRSR forming experiments with initial temperature of 450 °C for the billet and axial moving speed of 10 mm/s for the chuck in affirms the feasibility of producing hollow stepped shafts from high-strength Al–Zn–Mg–Cu alloy. Close agreement was found between simulated and experimental wall thickness variations. This study enhances understanding and optimization of TRSR forming for high-strength lightweight alloys, advancing industrial manufacturing methodologies.

Keywords

• Al-Zn-Mg-Cu alloy
• Constitutive model
• Microstructure evolution
• Three-roll skew rolling
• Hot processing map