Dimensional characteristics of grist intermediate products obtained in the first two technological passages in the reduction phase of an industrial milling plant

Abstract

After the wheat is coarsely grinded in the breakage technological phase and after a certain percentage of flour and bran has been extracted here, the crushing is continued in the reduction technological phase. The paper presents the flow of grist products at the first two technological passages from the reduction phase of an industrial milling unit. Samples taken from these two technological passages were subjected to a granulometric analysis, and with the experimental data a nonlinear correlation was performed with the Rosin-Rammler law, obtaining correlation coefficients of over 0.954. The paper also discusses the limits of the dimensions between which the particles of each fraction are sorted at the first two technological passages in the reduction phase. The analysis performed in this paper can serve in establishing the fabrics of the sifting frames from the plansifter compartments, respectively when adjusting the roller mills.