Enhanced removal of nano-oil droplets utilizing polysilicate aluminum ferric (PSAF): Leveraging bridging and non-polar surface advantages

Abstract

Hydraulic oil leaks during mechanical maintenance, resulting in flushing wastewater contaminated with dispersed nano-oil droplets. In this study, 75 mg L−1 of polysilicate aluminum ferric (PSAF) was stirred at 350 rpm and the optimal chemical oxygen demand (COD) removal was 71%. The increase of PSAF led to more hydrolysis of Fe, and 1,175 cm−1 hydroxyl bridged with negative oil droplets. At the same molar concentration, PSAF hydrolyzes cationic metals more rapidly than polymeric aluminum chloride (PAC). PSAF forms flocs of smaller complex structures with greater bridging. The Al–O and Si–O peaks occurred at 611 and 1,138 cm−1, indicating the formation of Si–O–Fe and Si–O–Al bonds on the flocs surface. Higher stirring speeds did not change the free energy of the flocs surface γTot, mainly because the decrease in the van der Waals force (γLW) offset the increase of Lewis acid–base force (γAB). Preserving the non-polar surface, in summary, owing to its bridging abilities and affinity for non-polar surfaces, PSAF demonstrates superior efficiency over PAC in capturing and removing oil droplets. HIGHLIGHTS 75 mg L−1 of PSAF was stirred at 350 rpm and the optimal COD removal was 71%.; PSAF bridging was superior to PAC in terms of Si–O–Fe and Si–O–Al bonds.; PSAF forms flocs of smaller complex structures with greater bridging.; Higher stirring speeds did not change the non-polar surface of PSAF flocs to have good adsorption.;

Keywords

• bridging
• free energy
• nano-oil droplets
• psaf
• stirring speed