Case Studies in Chemical and Environmental Engineering (Dec 2024)
Fabrication of PSf/P84-blended membranes with low P84 content: Characteristics and gas separation performance
Abstract
The demand for efficient and sustainable gas separation technologies is ever-increasing in various industries, including petrochemicals, natural gas processing, and carbon capture. Polymer-based membranes offer a promising solution due to their potential for high selectivity and energy efficiency. However, achieving optimal gas separation performance often requires overcoming the limitations of individual polymers through modifications such as polymer blending. In this study, PSf/P84 blended membranes with low P84 content were fabricated using the phase separation technique with a mixture of N-methyl-2-pyrrolidone and tetrahydrofuran as solvents. The effect of varying the mass ratio of PSf to P84 on membrane characteristics and gas separation performance was investigated. Characterization techniques included FTIR, XRD, SEM, TGA, Water Contact Angle (WCA) measurement, and mechanical property testing. Gas permeation tests were conducted with single gases at room temperature and 1 bar pressure. The results revealed that the addition of P84 increased membrane thickness, Young's modulus, and thermal stability, while decreasing d-spacing, dense layer thickness, hydrophilicity, tensile strength, and elongation. The Findex values, indicating the competence of the blended membranes compared to the ideal quality, demonstrated the positive impact of P84 addition on gas separation performance compared to pure PSf membranes. The optimal gas separation selectivity was achieved with the PSf/P84 1:0.025 blended membrane for H2/CH4 (11.28, 58 % increase), H2/CO2 (6.25, 193 % increase), and H2/N2 (5.25, 35 % increase). The highest N2/CH4 selectivity (6.29, 253 % increase) was observed with the 1:0.10 composition. Regarding commercially relevant separations based on the 2008 Robeson curve, the PSf/P84 1:0.20 blend showed promise for H2/CO2 separation, while the 1:0.05 and 1:0.10 blends were suitable for N2/CH4 separation.
