Клінічна та профілактична медицина (May 2024)

ANALYSIS OF THE FORM AND SURFACE OF DENTAL IMPLANTS

  • Viacheslav L. Bohdanov,
  • Oleksandr Ya. Grigorenko,
  • Valeriy V. Kremenicky,
  • Vladislav O. Malanchuk,
  • Hryhorii V. Sorochenko,
  • Roman G. Osnach,
  • Mikola M. Tormakhov

DOI
https://doi.org/10.31612/2616-4868.3.2024.06
Journal volume & issue
no. 3
pp. 46 – 54

Abstract

Read online

The aim of the work – to study the peculiarities of the shape and surface relief of the main types of dental implants. Materials and methods. 12 dental implants used in the medical practice of Ukrainian dental clinics were studied. The study of the shape and surface relief of the implants was carried out using a scanning electron microscope GSM-649 (Japan). Results. All implants in the apical part have the shape of a cone with threads and cutting grooves. The thread with a large profile is located in the apical part of the implant, has an average pitch of turns of 1.1±0.05 mm and a profile height of 0.3±0.02 mm. The thread with a small profile is located in the part of the implant near the neck, has a pitch of 0.4±0.02 mm and a profile height of 0.1±0.02 mm. The thread pitch of implants with a single profile is 0.8±0.05 mm, and the height of the profile is 0.2±0.01 mm. Threads with a triangular profile have a profile angle of 50.0±2.9 degrees. The highest roughness is the surface of the top of the fine profile thread with the height of micro-uniformities from 7.0±2.2 to 36.0±8.3 μm, the smallest roughness with the height of micro-uniformities from 3.0±1.1 to 14.0±6.1 μm have surface areas in the area of the implant neck. Conclusions. 50% of the examined implants were made with two thread profiles: a large one in the apical side and a small one closer to the neck, 50% – with the same thread profile from the apical end to the neck. In most implants, the thread with a small profile is made in the form of annular grooves. The large thread of the implants had a rectangular, rounded and triangular profile with one or two steps. In some implants, as they approach the neck, the shape changes and the height of the thread profile decreases. The shape of the profile of small threads in all implants was close to rounded. The implants had different surface roughness. The highest roughness was recorded on the surface of the top of the small profile thread, and the lowest – in the area without a thread in the area of the implant neck.

Keywords