Effect of micro-alloyed Ce on the microstructure evolution and mechanical properties of rolled Mg–0.6Al–0.5Mn–0.2Ca alloy sheets

Abstract

In this study, the effect of minor Ce addition (0, 0.1, and, 0.3 wt.%) on the microstructure evolution and mechanical properties of rolled Mg–0.6Al–0.5Mn–0.2Ca (AMX100) alloy sheets is systematically investigated under different annealing processes. With 0.1 wt.% Ce addition, partial Al8Mn5 phases turn into Al8Mn4Ce. With 0.3 wt.% Ce addition, the number of the Al8Mn4Ce further increases and the Al–Ce phases are observed. The single-stage annealed alloys exhibit similar uniform fine-grained structures (∼6 μm) regardless of the Ce content, while the grain sizes of the two-stage annealed alloys increase obviously (∼10.9–11.9 μm). Especially, the abnormal grain growth occurs in the two-stage annealed AMX100-0.3Ce alloy. After the aging treatment, the yield strength (YS) of the two-stage annealed alloys is increased by ∼25–45 MPa, which is greatly higher than that of the single-stage annealed alloys (∼1–8 MPa). Note that the two-stage annealed AMX100–0.1Ce alloy displays a significant age-hardening response with the ultimate tensile strength (UTS) of ∼272 MPa and the elongation to failure (EF) of ∼14%, which is attributed to the formation of Al and Ca enriched Guinier-Preston (G.P.) zones. This work sheds light on the design and fabrication of low-cost dilute magnesium alloys with admirable age-hardening ability.

Keywords

• Magnesium alloy
• Microstructure evolution
• Heat treatment
• Mechanical property
• Age-hardening response