Validation of Mometasone furoate and CIP100 Residue Analysis Methods After Cleaning of Production Equipment in the “XYZ” Pharmaceutical Industry

Abstract

In this study, the HPLC and Total Organic Carbon (TOC) analysis methods have been developed and validated for the determination of the amount of Mometasone furoate and CIP100 residues on the surface of production equipment and to confirm the efficiency of the cleaning procedure. Mometasone furoate and CIP100 have been chosen based on the worst case assessment approach. The limit of mometasone furoate contamination that has been determined is 100 ug/swab and the specified limit of CIP100 contamination is 100 ug/swab which should not be exceeded during sequential cleaning of the equipment. Mometasone furoate shows good linearity in the range 0.1-1.0 ppm for the HPLC method and CIP100 2.0-10.0 ppm for TOC Analysis. The percentage of recovery from stainless steel plates using swab sampling techniques was found in the limits of 95.12% and 99.93% respectively in the HPLC and TOC methods. Both methods are simple, inexpensive, short analysis time and high sensitivity for quantitative determination of Mometasone furoate and CIP100 on the surface of manufacturing equipment well below the contamination limit. The validated method meets the requirements for demonstration of the validation of residual cleaning of mometasone furoate and CIP100 on the surface of production equipment

Keywords

• mometasone furoate
• cleaning validation
• surfaces of production equipment
• analysis of total organic carbon (toc)
• hplc