Influence of thickness and surface conditioning on fracture resistance of occlusal veneer

Abstract

Abstract Background The purpose of the current study was to assess the impact of restoration thickness, surface conditioning and the interaction between them on the fracture resistance of CAD/CAM fabricated lithium disilicate occlusal veneers. Methods A total of 42 maxillary molars were prepared to receive CAD/CAM fabricated lithium disilicate occlusal veneer either with 0.5 mm (n = 21) or 1 mm (n = 21) thickness. Each main group was divided into 3 subgroups (n = 7), according to surface treatment, HF acid (HF-1, HF-0.5), acidulated phosphate fluoride (APF-1, APF-0.5) and Monobond etch & prime (MON-1, MON-0.5). Multilinik N (Ivoclar-Vivadent) adhesive resin cement was used for bonding according to the manufacturer instructions. One hour after bonding, specimens were stored in water bath for 75 days followed by cyclic loading fatigue for 240,000 cycles to simulate clinical situation. Finally, specimens were fractured under compressive load in (N) using a universal testing machine. Two and one-way ANOVA and Post Hoc Tukey test were used for statistical analysis. Results The means ± SD (N) fracture load for each group were calculated. MON-1 group showed the highest fracture load (1644.7 ± 155.3) followed by HF-1 group (1514.6 ± 212.5). Meanwhile, APF-0.5 showed the lowest fracture load (962 ± 249.6). Conclusion CAD/CAM fabricated lithium disilicate occlusal veneers can be used with a thickness of 0.5 mm instead of conventional crowns. Monobond etch & prime is recommended as a surface treatment for CAD/CAM fabricated lithium disilicate occlusal veneer due to biological hazards of Hydrofluoric acid.

Keywords

• Occlusal veneer
• Fracture resistance
• Surface treatment
• Thickness
• lithium disilicate
• CAD/CAM