Influence of geometrical and operational parameters on tooth wear in the working mechanism of a satellite motor

Abstract

Abstract This article describes the phenomena affecting the wear of the rotor of the working mechanism in a hydraulic satellite motor. The basic geometrical relationships that allow the calculation of the coordinates of the points of contact between the satellite and the rotor and the curvature are presented. A method for calculating the number of contacts of the satellite teeth with the rotor teeth and of the satellite teeth with the curvature teeth during one revolution of the rotor is proposed. A method of calculating the forces acting at the points of contact of the satellite with the rotor and the curvature is also proposed, as well as a method of calculating the stress in the tooth contact of the interacting components of the mechanism. The results of calculations of forces and stresses in tooth contact in a satellite mechanism consisting of a four-hump rotor and a six-hump curvature are presented. It is shown that the two chambers around the satellite are in the same phase in a certain range of the rotation angle of the rotor, i.e. in the emptying phase or in the filling phase. This results in the value of the force acting on the satellite resulting from the pressure difference being zero. It has also been shown that the most important parameters affecting tooth wear are the pressure difference in the working chambers of the satellite mechanism and the rotor speed.