DRX behavior and microstructure evolution of 33Cr23Ni8Mn3N: Experiment and finite element simulation

Hongchao Ji; Zhongman Cai; Weichi Pei; Xiaomin Huang; Yonghao Lu

Journal of Materials Research and Technology (May 2020)

DRX behavior and microstructure evolution of 33Cr23Ni8Mn3N: Experiment and finite element simulation

Hongchao Ji,
Zhongman Cai,
Weichi Pei,
Xiaomin Huang,
Yonghao Lu

Affiliations

Hongchao Ji: National Center for Materials Service Safety, University of Science and Technology Beijing, Beijing 100083, China; College of Mechanical Engineering, North China University of Science and Technology, Tangshan 063210, China; Corresponding authors.
Zhongman Cai: College of Mechanical Engineering, North China University of Science and Technology, Tangshan 063210, China
Weichi Pei: College of Mechanical Engineering, North China University of Science and Technology, Tangshan 063210, China; School of Mechanical Engineering, University of Science and Technology Beijing, Beijing 100083, China
Xiaomin Huang: College of Mechanical Engineering, North China University of Science and Technology, Tangshan 063210, China; School of Mechanical Engineering, University of Science and Technology Beijing, Beijing 100083, China
Yonghao Lu: National Center for Materials Service Safety, University of Science and Technology Beijing, Beijing 100083, China; Corresponding authors.

Journal volume & issue: Vol. 9, no. 3
pp. 4340 – 4355

Abstract

Read online

The dynamic recrystallization (DRX) behavior and microstructure evolution of 33Cr23Ni8Mn3N heat-resistant steel were studied by isothermal hot compression experiment within the temperature range of 1000 °C–1180 °C and strain rate of 0.01–10 s−1. Models for the DRX volume fraction and grain size of 33Cr23Ni8Mn3N heat-resistant steel were established, and comparison results showed high consistency for the predicted data from the models and those from scanning electron microscopy (SEM) and electron backscatter diffraction (EBSD). The model was imported into Deform-3D, and hot compression was simulated by the finite element method (FEM). The simulation and experimental results were highly consistent. Thus, the established DRX model is an important reference for the microstructure evolution in 33Cr23Ni8Mn3N hot deformation behavior.

Published in Journal of Materials Research and Technology

ISSN: 2238-7854 (Print); 2214-0697 (Online)
Publisher: Elsevier
Country of publisher: Netherlands
LCC subjects: Technology: Mining engineering. Metallurgy
Website: https://www.journals.elsevier.com/journal-of-materials-research-and-technology/

About the journal

Abstract

Keywords