Effect of Cooling Path on Microstructures and Hardness of Hot-Stamped Steel

Abstract

The final mechanical properties of hot-stamped steel are determined by the microstructures which are greatly influenced by the cooling process after hot stamping. This research studied the effect of the cooling path on the microstructures and hardness of 22MnB5 hot-stamped steel. The cooling path was divided into continuous and discontinuous (primary and secondary) processes. After cooling, the Vickers hardness along the thickness of the specimens was measured. The results indicate that, for a continuous cooling process, there was a critical cooling rate of 25 °C/s to obtain fully martensitic microstructure. For the discontinuous cooling process, the slower was the cooling rate, the higher was the degree of auto-tempering that occurred, and the greater was the amount of carbides that formed, regardless of the primary or secondary cooling rate. When the cooling rate was lower than the critical value, a higher primary cooling rate suppressed the auto-tempering of lath martensite and increased the quenched hardness. By contrast, the hardness was not sensitive to the cooling rate when it exceeded the critical value.

Keywords

• cooling path
• hot-stamping
• auto-tempering
• martensite
• hardness
• CCT