Effect of Carbon Black Nanofiller on Adhesion Properties of SBS Rubber Surfaces Treated by Low-Pressure Plasma

Abstract

Studies on the surface modification of commercial styrene-butadiene-styrene (SBS) rubber with different carbon black (CB) nanofiller content (10−80 parts per hundred parts of rubber (phr)) performed by low-pressure oxygen plasma are presented in this paper. The adhesion properties of the rubber were determined by the peel test for adhesive-bonded joints prepared with a water-based polyurethane (PU) adhesive. The chemical structure and morphology of the SBS rubber surface before and after plasma treatment were investigated by X-ray photoelectron spectroscopy (XPS) and scanning electron microscopy (SEM), respectively. The peel tests showed that the plasma treatment significantly improved the strength of adhesive-bonded joints in the entire range of CB tested, revealing a clear maximum for approximately 50 phr of CB. It was also found that as a result of plasma treatment, functional groups that are responsible for the reactions with the PU adhesive, such as C−OH and C=O, were formed, and their concentration, similar to the peel strength, showed maximum values for approximately 50 phr CB. The occurrence of these maxima was explained using the bound rubber model.

Keywords

• sbs rubber
• nano-carbon black
• cold plasma
• polymer surface modification
• adhesion
• bound rubber