Polymers (Feb 2021)

Carbon Fiber Reinforced Multi-Phase Epoxy Syntactic Foam (CFR-Epoxy-Hardener/HGMS/Aerogel-R-Hollow Epoxy Macrosphere(AR-HEMS))

  • Xinfeng Wu,
  • Yuan Gao,
  • Tao Jiang,
  • Ying Wang,
  • Ke Yang,
  • Tengshi Liu,
  • Kai Sun,
  • Yuantao Zhao,
  • Wenge Li,
  • Jinhong Yu

DOI
https://doi.org/10.3390/polym13050683
Journal volume & issue
Vol. 13, no. 5
p. 683

Abstract

Read online

Because the aerogel has ultra-low density and good impact resistance, the aerogel material, epoxy-hardener system, and expandable polystyrene beads (EPS) were used to prepare the lightweight aerogel reinforced hollow epoxy macro-spheres (AR-HEMS). The multi-phase epoxy syntactic foam (ESF) was manufactured with the epoxy-hardener system, HGMS (EP-hardener-HGMS), and AR-HEMS by “the compression modeling method.” In this experiment, in order to enhance the strength of the ESF, some different kinds of the carbon fiber (CF) were added into the EP-hardener-HGMS system (CFR-EP). The influence of the volume stacking fraction, inner diameter, and layer of the AR-HEMS and the content and type of the CF in the EP-HGMS (CFR-EP) system on the compressive strength of the ESF were studied. Weighing the two factors of the density and compressive strength, the ESF reinforced by 1.5 wt% CF with 90% AR-HEMS has the better performance. This kind of the ESF has 0.428 g/cm3 nd 20.76 Mpa, which could be applied in 2076 m deep sea.

Keywords