An in vitro comparative evaluation of the fracture resistance of teeth with mesio-occluso-distal preparations restored with different esthetic materials by bulk-fill and incremental methods

Abstract

Introduction: One of the most popular restorative materials today is resin-based composite. Volumetric shrinkage is brought on by polymerization, which can cause contraction stress, microleakage, and adhesion failure. Adhesive restorations have several benefits, including the ability to preserve more healthy tissue and “reinforce” the remaining tooth structure. These benefits go beyond just being attractive. Materials and Methods: Eighty extracted human maxillary premolars were entrenched in a self-cured acrylic resin in a rubber mold cylinder (2.5 cm width-3 cm height). These were arbitrarily divided into 5 groups: 2 control groups (positive control group and negative control group) (n = 10) and 3 experimental (n = 20) groups (microhybrid composite, nanocomposite, and Giomer). The mesio-occluso-distal (MOD) cavities were prepared in 70 samples. After MOD cavities preparation, groups were further subdivided into two subgroups for bulk-fill and incremental methods. Universal Tofflemire Retainer and band were placed on the prepared cavities. The self-etch adhesive was applied on all aspects of the preparations and then it was light-cured using a light-curing unit for 15 s. Now, cavities were restored with different esthetic materials and methods. In the bulk-fill method, the MOD cavity was restored with a solitary increase of restorative material and light cured from all directions of tooth for 20 s each. In the incremental technique, the proximal box on both sides was reconstructed first in a gradual manner, in which two oblique increments and one horizontal increment were restored and treated for 20 s. Then, two oblique increments of material were used to reestablish the occlusal component, and it was once more light-cured for 20 s. Fracture resistance was checked using a steel bar with a diameter of 4.5 mm that was positioned in the middle of the occlusal surface and a crosshead speed of 3 mm/min, all of the samples were compressed axially loaded. Results: The fracture resistance of microhybrid composite resins in bulk technique was significantly higher than that of nanocomposites and Giomer. However, the fracture resistance of nanocomposite in the incremental method was significantly higher than the other two restorative materials. Conclusion: The quality of restoration depends both on the material and method used during the restoration procedure. Both factors are dependent on each other. Superior fracture resistance was shown by microhybrid composites when restored with the bulk-fill technique and nanohybrid composites when restored with the incremental technique.

Keywords

• bulk technique
• giomer
• incremental technique
• microhybrid composite
• nanocomposite