Energy Science & Engineering (Dec 2021)

Estimation of radiation dose resulting from the recycling of large metal wastes from decommissioning nuclear power plants in Korea

  • Jin Ho Son,
  • Tae Young Kong,
  • Ho Yeon Yang,
  • Seong Jun Kim,
  • Eun Ji Lee,
  • Wo Suk Choi,
  • Woon Kwan Chung,
  • Hee Geun Kim

DOI
https://doi.org/10.1002/ese3.995
Journal volume & issue
Vol. 9, no. 12
pp. 2206 – 2214

Abstract

Read online

Abstract Following the permanent shutdown of Kori Unit 1 in June 2017, the Republic of Korea has been preparing for full‐scale decommissioning work. In addition, the design life of 12 units will expire by 2030. If decommissioning begins without initially extending the lifespan of nuclear reactors, massive amounts of decommissioning wastes will be generated in a short period. The total amount of radioactive wastes generated during the dismantling of a pressurized water reactor is estimated as 6200 tons, and approximately 70% of the total radioactive wastes are classified as metal wastes. Self‐disposal through the decontamination of contaminated metals can contribute to the economic feasibility of decommissioning nuclear power plants because it can reduce the disposal cost of medium‐ and low‐level radioactive wastes. Therefore, this study evaluated the possibility of self‐disposal of steam generators that may occur during future decommissioning. The radioactivity analysis data on transferring the replaced steam generator of Hanul Unit 1 were used as the source term. The decontamination factor was calculated by applying 200 units from 1200 to 2000, and the radiation dose was evaluated using the RESRAD‐RECYCLE code. Consequently, the single‐nuclide concentration and sum of the allowable concentration fraction for mixed radionuclides at a decontamination factor of 1400 were below the regulatory requirements; however, the dose evaluation results exceeded the allowable dose in some scenarios. The decontamination factor was 2000, when the dose evaluation results for all scenarios met the regulatory requirements.

Keywords