A Bi-State Shape Memory Material Composite Soft Actuator

Abstract

Shape memory materials have been widely used as programmable soft matter for developing multifunctional hybrid actuators. Several challenges of fabrication and effective modelling of these soft actuating systems can be addressed by implementing novel 3D printing techniques and simulations to aid the designer. In this study, the temperature-dependent recovery of an embedded U-shaped Shape Memory Alloy (SMA) and the shape fixity of a 3D-printed Shape Memory Polymer (SMP) matrix were exploited to create a bi-state Shape Memory Composite (SMC) soft actuator. Electrical heating allowed the SMA to achieve the bi-state condition, undergoing phase transformation to a U shape in the rubbery phase and a flat shape in the glassy phase of the SMP. A COMSOL Multiphysics model was developed to predict the deformation and recovery of the SMC by leveraging the in-built SMA constitutive relations and user-defined material subroutine for the SMP. The bi-state actuation model was validated by capturing the mid-point displacement of the 80 mm length × 10 mm width × 2 mm-thick 3D-printed SMC. The viability of the SMC as a periodic actuator in terms of shape recovery was addressed through modelling and simulation. Results indicated that the proposed COMSOL model was in good agreement with the experiment. In addition, the effect of varying the volume ratio of the SMA wire in the SMC on the maximum and recovered deflection was also obtained. Our model can be used to design SMC actuators with various performance profiles to facilitate future designs in soft robotics and wearable technology applications.

Keywords

• soft actuators
• soft robotics
• shape memory material
• shape memory alloy
• shape memory polymer
• composite actuator