Crystals (Oct 2020)

Numerical Simulation of Melting Kinetics of Metal Particles during Tapping with Argon-Bottom Stirring

  • Kinnor Chattopadhyay,
  • Rodolfo Morales-Davila,
  • Alfonso Nájera-Bastida,
  • Jafeth Rodríguez-Ávila,
  • Carlos Rodrigo Muñiz-Valdés

DOI
https://doi.org/10.3390/cryst10100901
Journal volume & issue
Vol. 10, no. 10
p. 901

Abstract

Read online

Molten steel is alloyed during tapping from the melting furnace to the argon-bottom stirred ladle. The metallic additions thrown to the ladle during the ladle filling time are at room temperature. The melting rates or kinetics of sinking-metals, like nickel, are simulated through a multiphase Euler–Lagrangian mathematical model during this operation. The melting rate of a metallic particle depends on its trajectory within regions of the melt with high or low turbulence levels, delaying or speeding up their melting process. At low steel levels in the ladle, the melting rates are higher on the opposite side of the plume zone induced by the bottom gas stirring. This effect is due to its deviation after the impact of the impinging jet on the ladle bottom. The higher melting kinetics are located on both sides at high steel levels due to the more extensive recirculation flows formed in taller baths. Making the additions above the eye of the argon plume spout increases the melting rate of nickel particles. The increase of the superheat makes the heat flux more significant from the melt to the particle, increasing its melting rate. At higher superheats, the melting kinetics become less dependent on the fluid dynamics of the melt.

Keywords