SEISMIC ANALYSIS OF NUCLEAR POWER PLANT CANNED MOTOR PUMP UNIT BASED ON INTEGRAL CALCULATION METHOD

Civil Engineering Journal. 2016;2016(4) DOI 10.14311/CEJ.2016.04.0026

 

Journal Homepage

Journal Title: Civil Engineering Journal

ISSN: 1805-2576 (Online)

Publisher: Czech Technical University, Prague

Society/Institution: Czech Technical University in Prague, Faculty of Civil Engineering

LCC Subject Category: Technology: Engineering (General). Civil engineering (General)

Country of publisher: Czech Republic

Language of fulltext: Czech, English

Full-text formats available: PDF

 

AUTHORS

Li Zhenggui (Key Laboratory of Fluid and Power Machinery, Ministry of Education, Xihua University, Chengdu, 610039, China)
Li Muyu (Key Laboratory of Fluid and Power Machinery, Ministry of Education, Xihua University, Chengdu, 610039, China)
Zhang Jiarong (Key Laboratory of Fluid and Power Machinery, Ministry of Education, Xihua University, Chengdu, 610039, China)
Li Bo (Key Laboratory of Fluid and Power Machinery, Ministry of Education, Xihua University, Chengdu, 610039, China)
Liu Xiaobing (Key Laboratory of Fluid and Power Machinery, Ministry of Education, Xihua University, Chengdu, 610039, China)
Yang Fengyu (Key Laboratory of Fluid and Power Machinery, Ministry of Education, Xihua University, Chengdu, 610039, China; Institute of Energy and Power Engineering, Lanzhou University of Technology, Lanzhou 730050, China)

EDITORIAL INFORMATION

Double blind peer review

Editorial Board

Instructions for authors

Time From Submission to Publication: 6 weeks

 

Abstract | Full Text

The canned motor pump is a device in one of the most important loops in the nuclear power plant system and key technology research project, of which the seismic requirements shall be checked by Category A. It is required that the structural integrity and electric drive assembly performability of the unit can be ensured during or after operating basic earthquake (OBE) or safe shutdown earthquake (SSE). The author uses Ansys software workbench module to carry out appearance-based three-dimensional modeling, finite element meshing, intrinsic mode analysis, and carry out structural overall element analysis and calculation considering dead weight load and earthquake spectrum load. The results show that the unit major structure rotary and static parts, gear system, bearing parts, bolt and screw strengths meet the requirements and the structure maintains integrity, the relative deformation of the unit rotary and static parts shall be less than the specified value of gap among them, so as to keep the performability and not interfere with the operation. The appearance–based seismic analysis method not only can ensure the calculation accuracy, but also can greatly reduce the workload in calculation and checking, has a certain learning value.