Proof of concept for a wrist mechanism for articulated forceps for use in robot-assisted laparoscopic surgery

Abstract

Abstract Laparoscopic surgery is a minimally invasive surgery that accelerates postoperative recovery, but it can only be performed by surgeons with advanced surgical skills. One of the main difficulties in laparoscopic surgery is the restriction of free motion of the forceps because of the limited degrees of freedom by the trocar. Recently, many master–slave manipulators with articulated forceps have been used in laparoscopic surgery to solve this problem. The wrist mechanism of an articulated forceps affects the controllability and range of motion of a slave manipulator in a patient’s abdominal cavity. Therefore, it is important to improve upon the wrist mechanism of articulated forceps for robot-assisted laparoscopic surgery. This paper aims to propose a new wrist mechanism for articulated forceps to be used in laparoscopic surgery. The degrees of freedom of the proposed design are three motor-driven axes that use wires and pulleys (a pitch axis, yaw axis, and gripper axis) and a roll axis driven by manual rotation of the forceps shaft. In the proposed mechanism, the offset distance between the pitch and yaw axes was reduced. The offset value, i.e., 5.95 mm, is shorter than the maximum outer diameter 7.5 mm of the wrist mechanism. Singularity configurations of the wrist axes are avoided near the standard working posture by configuring the pitch and yaw axis. There are few parts and it is simple as compared to the previously developed clinical use robotic forceps. Furthermore, the effectiveness of the proposed mechanism was verified by tests. The range of pitch motion is ± 90°, yaw motion is ± 85° (or ± 90°), and gripper motion is 60° (or 50°). The transmission efficiencies are from about 55 to 75%. The grasping force and torque are more than 5 N and 70 mNm.

Keywords

• Surgical robotics
• Minimally invasive surgery
• Wire drive mechanism
• Forceps
• Master–slave manipulator