Applied Sciences (Nov 2023)
Constitutive Model of Bond-Slip between Rubber Granule–Basalt Fiber Composite Modified Concrete and Rebar
Abstract
The bonding properties between rubber granule–basalt fiber composite modified concrete (RBFC) and rebar greatly impact the load-carrying capacity, stiffness, and crack development of RBFC structures. In this paper, the effects of rebar diameter, bonding length, and concrete type on the bonding properties between RBFC and rebar were investigated using center pull-out tests. The bond stress–slip curve as well as the bond strength and its influencing factors were discussed in detail, and a semi-theoretical and semi-empirical model of RBFC with rebar was established. According to the findings, when rubber granules were added to concrete, its bond strength with rebar decreased. At a dosage of 5%, the bond strength was reduced by approximately 4% compared to ordinary concrete (OC) under the same conditions. It was shown that the addition of small amounts of rubber granules did not significantly reduce the bond strength. On the other hand, the incorporation of an appropriate amount of basalt fibers had a positive effect on the bond strength. An admixture of 4.56 Kg/m3 of fibers increased the bond strength by 3% compared to OC under the same conditions. The bond strength of RBFC with these two additions was improved by approximately 2% compared to OC under the same conditions. When the bonding length was 60 to 100 mm, the ultimate bond strength decreased with increasing bonding lengths. The bond strength decreased by 13.91–16.72% for every 20 mm increase in bonding length. When the rebar diameter was 12 to 16 mm, the ultimate bond stress decreased as the rebar diameter increased. The bond strength decreased by 3.96–5.94% for every 2 mm increase in rebar diameter. The segmental bond–slip constitutive model between RBFC and rebar, established using the results of the center pull-out test, can provide a reference basis for engineering applications of RBFC.
Keywords
