Numerical analysis of the heat transfer performance of the absorber tube of a parabolic trough solar collector using the swirling flow technique

Abstract

In the present work, the absorber tube of the DISS (Direct solar steam) solar plant in Plataforma Solar de Almeria (Spain) is powered by fluid flows in a swirl motion. Numerical simulations are used to predict the performance of a parabolic trough solar collector with inlets that allow the working fluid to flow in a swirl motion inside the absorber tube. There are numerous sites for tangential inlets distributed along the absorber tube. There is one inlet placed up, one located down, two located up, and two located down. High Reynolds numbers between 2.2 × 105 and 6.2 × 105 are used for the simulation. When the collector with the tangential inlet is compared to a conventional collector, the results reveal that using one inlet down causes a 9.1K decrease in the average temperature of the lower surface of the absorber tube. Compared to axial flow, one inlet down increases useful heat and heat transfer by 12.7 % and 41.7 %, respectively. The average friction factor of axial flow is 16.4 % higher than that of one inlet down. The collector with a tangential inlet reduces surface area by 10.9 % over Reynolds ranges when compared to an axial flow collector. Therefore, the thermal strain on the absorber tube and collector surface area is reduced by the swirling flow in the parabolic trough solar collector. As a helpful design tool, thermal performance correlations of absorber tubes with tangential inlets are constructed.

Keywords

• Direct solar steam
• Absorber tube
• Swirling
• Solar power plant
• Parabolic trough collector