How Does the Micro-Groove Profile Influence the Mechanics of Taper Junction in Hip Implants? A Finite Element Study

Abstract

This study aims to investigate the effect of ridged (micro-grooved) surface finish over the trunnion surface on the mechanics (stress, strain, and deformation) of the head–neck taper interface in hip implants. Using finite element modelling, the study focused on the geometric parameters of such micro-grooves to study how they would mechanically affect stress and deformation fields after the assembly procedure. As such, five different 2D models with varying micro-groove height and spacing were produced and assembled under an impaction assembly force of 4 kN in a 32 mm CoCrMo head engaged with a 12/14 Ti-6Al-4V neck. The results showed that lower von Mises stresses could be induced by either an increase or decrease in spacing against the base model (Model 1), which probably signifies that the relationship between the ridge spacing and stress may depend on the level of spacing. It was concluded that the geometrical parameters of the ridges (and their non-linear interactions) impact not only the stress and strain fields but also the assembly loading time at which the maximal stress and plastic deformation occur.

Keywords

• micro-grooves
• taper junction
• hip implants
• finite element modelling