Microstructure Transformation in Laser Additive Manufactured NiTi Alloy with Quasi-In-Situ Compression

Abstract

For NiTi alloys, different additive manufacturing processes may have different compressive recovery capabilities. In particular, there are relatively few studies on the compressive recovery ability of NiTi alloys by the laser-directed energy deposition (LDED) process. In this paper, the compression recovery properties of NiTi alloys with the LDED process were investigated quasi-in-situ by means of transmission electron microscopy, an electron backscatter diffractometer, and focused ion beam–fixed-point sample preparation. The results showed that the material can be completely recovered under 4% deformation and the B19’ martensite phase content and dislocation density are basically unchanged. However, the recovery rate was only 90% and the unrecoverable strain was 0.86% at 8% deformation. Meanwhile, the B19’ martensite phase content and dislocation density of the material increased. Furthermore, with the increase in deformation, the relative dislocation pinning effect of the Ti2Ni precipitated phase in the alloy was enhanced, which reduced the compressive strain recovery to a certain extent.

Keywords

• laser additive manufacturing
• compression
• microstructure transformation
• dislocation pinning
• recovery ability