Perovskite half tandem v-shaped grating nanostructure solar cells: Improvement by light trapping and carrier transfer towards efficiency enhancement

Abstract

In this paper, the enhancement of the perovskite solar cells (PSCs) efficiency through the implementation of a half-tandem structure featuring two absorbent layers of MAPbI3 and MoTe2 with a V-shaped nanostructured grating was investigated. MoTe2 was utilized as the second lower absorbent with a smaller bandgap than the first and upper absorbent, MAPbI3, to cover the incident light absorption in the infrared wavelength range. Additionally, the structure was also optimized by introducing a nanostructured V-shaped grating to increase the light propagation path and improve the absorption in the active layers. Also, the critical role of the electron transfer layer (ETL) and hole transfer layer (HTL) in carrier transfer and prevention of charge leakage was examined for materials including TiO2, TiO2-Gr (5%) nanocomposite, and Al-doped ZnO (AZO) as ETLs, and Cu2FeSnS4 (CFTS) and reduced Graphene Oxide (rGO) as HTLs in four distinct cell configurations. In this study, the optical and electrical models were solved to determine the optimal solar cell structure and materials through a comparative analysis of structures. Our findings revealed substantial improvements in short-circuit current density (Jsc), open-circuit voltage (Voc), and power conversion efficiency (PCE), where they increased from 15.27 to 31.55 mA/cm2, 0.91 to 1.30 V, and 11.78 to 27.63%, respectively. This resulted in a 2.35 times efficiency enhancement for the nanostructured V-shaped half-tandem solar cell with MAPbI3 (250 nm) and MoTe2 (150 nm) as absorbent layers, AZO (40 nm) as ETL and rGo (40 nm) as HTL compared to the planar non-tandem solar cell with MAPbI3 (250 nm) as absorbent layer, TiO2 (40 nm) as ETL and CFTS (40 nm) as HTL.

Keywords

• Perovskite Solar Cells (PSCs)
• Half tandem
• V-shaped grating
• Hole Transfer Layer (HTL)
• Light trapping