The Flow Resistance of the Filter Bags in the Dust Collector Operating in the Line of Wood-Based Furniture Panels Edge Banding

Abstract

The article describes the process of forming the wood dust filtration resistance generated during furniture production using the honeycomb board technology in a filtering installation operating in industrial conditions. The influence of the service life of the filter fabric on the filtration resistance values in industrial conditions for one installation and one type of filter fabric was analyzed. For this purpose, filter bags made of one type of filter material were used in an industrial filtering installation at four different times. The results were compared to those previously obtained at the same factory but with a different filter bag type. The analysis was based on the changes in the flow resistance of clean and dust-laden air through the filter fabric used at various times in the filtering installation of the narrow-surface treatment line in a furniture factory. This allowed for the determination of the dynamics and nature of changes in filtration resistance in industrial conditions for wood dust. The values of the dust resistance coefficient depend on the operating time and increased to the level of 20594 [s−1] for material A and from 6412.031 [s−1] to 10128.94 [s−1] for material B. The dimensional characteristics of the filtered dust and the technological conditions under which it was generated were also described.

Keywords

• pulse-jet filter
• filter bag
• wood dust
• dust resistance
• filtration time