Study of the Dependence of the Properties of the Ti EBPVD Layer Deposited on the Inner Surface of the Tube on the Position of the Evaporated Target Using the Statistical Methods

Abstract

This article presents the properties of a Ti coating (angle of grain growth, thickness of the deposited layer, adhesion, and roughness of the deposited layer) deposited on the inner surface of a steel tube. The Ti coating was deposited using the EB PVD (electron beam physical vapor deposition) method. The areas in which the measurements were carried out are defined by the height of the measured area under the target (from 305 to 425 mm) and the radius of the tube (from 100 to 140 mm). The measurements showed that the angle of grain growth is in an interval from 40 to 61°. The results of the statistical analysis demonstrate that the height of the measured area and the tube radius significantly impact the angle of grain growth and adhesion. On the other hand, the impact of the height of the measured area and the tube radius on the roughness of the applied coating was not confirmed.

Keywords

• Ti layer
• EB PVD
• mechanical properties
• method ANOVA
• regression and correlation analysis