Heliyon (Jul 2024)
Effect of Cd on Structural, Spectral, Morphological and Dielectric Properties of Sr1-xCdxZn2Fe4O11 R-type Hexaferrites Synthesized via Sol-gel Technique
Abstract
Sol–gel method was used to prepare Sr1-xCdxZn2Fe4O11 (x = 0.00, 0.02, 0.06, 0.1) R-type hexaferrite. The synthesized materials were sintered at 850oC and desired phase was obtained. X-ray diffraction analysis confirms that R-type hexaferrite exists only as a single phase. Using the Scherer formula, crystallite size for all of the prepared samples was found to be in the range of 10.39–12.62 nm. Crystallite size (D), the lattice parameters (a, c), and the cell volume (Vcell), d-spacing, bulk density, X-ray density, porosity, dislocation density and micro strain were determined in structural analysis. Fourier transform infrared spectroscopy method was used to identify the metal-oxygen vibrations at different locations. FT-IR verifies the presence of the Fe–O stretching vibration band at 743 and 867 cm−1. The typical grain size in surface morphology investigation ranges from 0.56 to 0.82 μm. Dielectric response of ferrite ceramic samples replaced with Cd2+ was investigated in the frequency range of 1 MHz–3 GHz. The AC conductivity rises with an increase in frequency because they are proportional to one another. This increasing tendency is effectively described by the theory of Maxwell-Wagner and Koop. Q-values remain constant as frequency rises and behaves independently of frequency as long as frequency reaches 1.7 GHz. These types of materials are utilized in high-frequency applications including frequency filters and resonant circuits. All of the magnetic properties determined by analyzing the M − H loops, including saturation magnetization (Ms), retentivity (Mr), and coercivity (Hc), exhibit an increasing trend as the substitution of Cd2+ rises. Ms (49.76–56.38 emu/g), Mr (15.82–18.30 emu/g) and Hc range from 203.20 Oe to 215.80 Oe. Grain size decreases cause arise in coercivity, which is caused by an enhancement in magneto-crystalline anisotropy. Overall results suggest that Cd2+ replaced R-type hexagonal ferrites are a great resource for longitudinal recording media; they have the potential to be used in a wide variety of electronic applications, including resonant circuits and high-frequency filters, security, detecting and switching.