An investigation of the effect of drawdown pressure on sand production in an Iranian oilfield using a hybrid numerical modeling approach

Abstract

Abstract Reservoir pressure reduction due to continuous production from oil and gas wells affects the sand production rate. An increase in drawdown pressure and/or a decrease in reservoir pressure increases the sand production rate. Since the problem of sand production is one of the main issues in the Asmari sandstone formation located in one of the oilfields in the southwest of Iran, therefore, in this research, the variations in the sand production rate due to the changes in the reservoir and drawdown pressures were investigated. So, for the first time, a hybrid numerical model of finite difference method (FDM)—discrete element method (DEM)—finite element method (FEM)—computational fluid dynamics (CFD) was developed. This numerical model investigated the increase in the sand production rate due to variations in reservoir pressure with a constant bottom-hole flowing pressure. Then, by performing an extensive sensitivity analysis on different values of reservoir pressure and drawdown pressure, the changes in the sanding rate, the critical drawdown pressure, and the safe drawdown line were determined. The results showed that, if the production flow rate of the well is constant, increasing the drawdown pressure can change the sand production rate only to a certain extent, and more than that, will be produced at a constant rate. Also, adjusting the drawdown pressure within a safe range does not necessarily keep the sand production rate constant at a permissible value for a long time, while by keeping the bottom hole flowing pressure constant within an acceptable range, the sand production rate can be controlled for a longer period.

Keywords

• Sand production
• Bottom hole flowing pressure
• Reservoir pressure
• Critical drawdown pressure
• Numerical modeling
• Safe drawdown line