Materials (Mar 2022)

Influence of Asymmetric Rolling Process on the Microstructure Properties of Bimetallic Sheet Metals

  • Grzegorz Stradomski,
  • Dariusz Rydz,
  • Tomasz Garstka,
  • Michał Pałęga,
  • Tomasz Dyl,
  • Arkadiusz Szarek,
  • Justyna Łukomska Szarek,
  • Tomasz Dembiczak

DOI
https://doi.org/10.3390/ma15062013
Journal volume & issue
Vol. 15, no. 6
p. 2013

Abstract

Read online

This paper presents the results of research on the determination of the influence of kinetic asymmetry of work rolls on structural changes in hot-rolled bimetallic sheet metals. The tests were conducted on bimetallic samples composed of materials 10CrMo9-10 + X2CrNiMo17-12-2. The scope of the research included a comparative analysis for two cooling variants: I in water (freezing the structure immediately after rolling) and II for cooling in air. The research conducted showed that the introduction of asymmetric conditions to the rolling process results in a greater grain fragmentation in the so-called hard layer and does not have a negative effect on microstructural changes in the soft layer.

Keywords