Effects of cryogenic pre-deformation on the microstructure and mechanical properties of Ti–Mo alloys

Abstract

In the present study, pre-deformation at liquid nitrogen temperature (77 K) was applied to introduce twins into Ti–Mo alloys with different contents of molybdenum. The microstructural evolution and mechanical properties with different cryogenic pre-deformation amounts (from 0 to 9 %) were characterized and analyzed. The results show that the twinning activities and the evolution of twinning systems are mainly influenced by β phase stability and cryogenic pre-deformation amount. After cryogenic pre-deformation, the primary and secondary twinning of {332}twins are observed in Ti–12Mo and Ti–15Mo alloys but absent in Ti–20Mo alloy. With the cryogenic pre-deformation amounts increasing, the width and quantity of twins increase constantly. Moreover, {112}twinning is activated in Ti–15Mo alloy pre-deformed by 6 % and 9 %. Twins and high-density dislocations induced by cryogenic pre-deformation cause a significant enhancement in strength of all these three alloys. However, the effect of cryogenic pre-deformation on the elongation of alloys is complicated. For Ti–12Mo alloys, the yield strength increases monotonically (from 527 to 778 MPa) with the increase of cryogenic pre-deformation reduction, while the elongation is completely opposite (from 47 to 20 %). For Ti–15Mo alloys, the optimal matching of strength and ductility is achieved when the amount of cryogenic pre-deformation is 6 %, with a tensile strength of 815 MPa and an elongation of 24 %. Compared with the other two alloys, Ti–20Mo alloy gets a smaller increase in strength and a slight decrease in elongation with the amount of cryogenic pre-deformation increasing.

Keywords

• Titanium alloy
• Cryogenic pre-deformation
• Twin
• Mechanical properties