Non-Conventional Hybrid Microporous Layers for Enhanced Performance and Durability of PEM Fuel Cells

Abstract

In this work, novel microporous layers (MPLs) were developed based on fluorinated ethylene propylene (FEP), as a hydrophobic agent, and carboxymethylcellulose (CMC), as a wettability modulator and rheology controller for the inks, which were deposited onto pre-hydrophobized macroporous gas diffusion layers (GDLs). Higher CMC amounts led to higher dynamic viscosities of the inks, which induced the formation of a more compact and less cracked MPL surface. Different concentrations of CMC were tested and the experimental measurements showed a threshold limit pointing out an optimal composition that positively affected the electrochemical performances at medium-low relative humidity (RH), which is important to mitigate the need of saturating inlet gases. Durability of the best performing samples was assessed by means of an ad hoc developed accelerated stress test (AST) and compared to one of the conventional FEP-based GDMs. It was found that a lower decrement of both the output power density and the overall cell efficiency can be obtained upon the ASTs with the novel samples.

Keywords

• PEM fuel cells
• gas diffusion layer
• MPL
• coating
• hydrophobicity
• durability