Journal of Economic Geology (May 2023)
Zircon/rock partitioning coefficients of REEs, Y, Th, U, Nb, and Ta in Sarnowsar, Sarkhar and Bermani granitoids: Use for magma source and mineral exploration
Abstract
In this research, to contribute to the understanding of the geochemistry of trace elements in zircon, we determined the REEs, Y, Nb, Ta, Th, and U contents in zircon grains in three granitoids (Sarnowsar, Sarkhar and Bermani) by laser ablation-inductively coupled plasma-mass spectrometry (LA-ICP-MS) in order to determining the magma sourcee and magmatism fertility. The zircon/rock partitioning coefficients of REE, Y, Nb, Ta, Th, and U contents indicate that the patterns of the trace elements of the studied granitoids are controlled by the liquid composition at the magmatic crystallization. Compared to Sarkhar and Bermani granitoids, the Sarnowsar granite has a higher temperature (736° to 915 °C), higher zircon/rock partitioning coefficient of REEs, Y and Th (up to 2770 for Zr) and it was formed in higher oxidant conditions (△FMQ values between -0.06 to 17.01). The results of this study show that oxidized and I-type magmas in subduction-related tectonic environments are more favorable for porphyry and skarn mineralization. Introduction Zircon is the most commonly analyzed accessory mineral and is routinely employed in U–Th–Pb geochronology, (U–Th)/He and fission track thermochronology, radiogenic (Hf) and stable (O) isotopic studies, crystallization thermometry, and trace element geochemistry (Belousova et al., 2002). A critical presumption in zircon chemistry studies is that data obtained from zircon is a proxy for the parent igneous rock. This is evidently true for most types of analyses, however, relating trace element and rare earth element (REE) concentrations in zircon compared to bulk rock or melt concentrations has been verified for causing some difficulties. The incentive to establish more accurate estimates of parental bulk rock concentrations using in-situ zircon measurements is significant as it would link zircon to a large body of whole rock geochemical literature with numerous possible applications including studies of magma source, crustal thickness, mineral exploration, crustal evolution, metamorphism, and petrogenesis (Chapman et al., 2016 and references therein). In this research, we determined the contents of REEs, Y, Nb, Ta, Hf, U, and Th in the zircon grains of eight granitoid samples from the Sangan mining district, NE Iran, to calculate zircon/rock partitioning coefficients of REEs applicable to magma source studies and mineral exploration. Material and methods Zircon from Sarkhar and Bermani granitoids were analyzed at the State Key Laboratory of Geological Processes and Mineral Resources, China University of Geosciences, Wuhan, using laser ablation system, ICP-MS instrument (Agilent 7700a ICP-MS). Also, samples from Sarnowsar granitoids were analyzed at the Nanjing Hongchuang Geological Exploration Technology Service Co. Ltd., China. Zircons were analyzed for trace elements using a laser energy density of 3.6 J/cm2, a spot size of 30 μm, and a repetition rate of 5 Hz. The estimations of melt composition and the measured trace element concentrations in zircon, values of DCezircon/rock was calculated. Estimates for DCe3+zircon/rock and DCe4+zircon/rock were implemented after Ballard et al. (2002) method. Partition coefficients of the trivalent REEs and the quadrivalent series Hf, Th, and U are used to constrain DCe3+zircon/rock and DCe4+zircon/rock, respectively. Blundy and Wood (1994) showed that the mineral melt partition coefficient for a cation i can be related to the lattice strain energy created by substituting a cation, whose ionic radius (ri) differs from the optimal value for that site (r0) (Equation 1). lnDi=lnD0-4π ENA/RT (ri/3+r0/6) (ri- r0)2 (1) Plotting lnDi against the (ri/3 +r0/6)(ri−r0)2 yields a linear relation for an isovalent series of cations. With knowing the ionic radii of Ce3+ and Ce4+, partition coefficients of these species can be determined by interpolation. Since Ce will be a mixture of Ce3+ and Ce4+, the value of DCezircon/rock will lie between these two-partition coefficient end-members, and by combining Equations (1) and (2) oxygen fugacity fO2 of crystallization can be estimated. ln[xmelt Ce4+/ xmelt Ce3+]= 1/4 ln fO2 + 13136 (±591)/T − 2.064 (±0.011) NBO/T −8.878(±0.112).xH2O −8.955 (±0.091) (2) Temperatures were calculated using the Ti content of zircon, by using the Equation (3) (Ferry and Watson, 2007): log(Tizircon) = (5.711 ± 0.072) – 4800 ± 86/T −logaSiO2 + logaTiO2 (3) where Tizircon is the concentration of Ti in zircon in ppm, T is temperature degrees in Kelvin, and ai (aSiO2 and aTiO2) is the ratio of component i concentration in the melt over the concentration of component i in the rock at saturation. Results and discussion Concentrations of trace elements in the zircon grains are given in the Supplementary Table and are summarized in Table 1, where the geometric mean (G), the variation coefficient CV (which corresponds to the ratio of standard deviation by the arithmetic mean), and the number of determinations (n) are listed. Heavy rare earth elements (HREEs) show a relative enrichment. (Lu)N in the Sarnowsar granitoids range from 1522.40 to 8869.00 (DA sample), 1477.00 to 6442.00 (TP sample) and 1655.37 to 53.00 7523 (CSK sample). These values for Sarkhar and Bermani granitoids are in the range of 835.43 to 4077.95 (BR-01 sample), 1233.46 to 4337.80 (SK-01 sample), 1984.37 to 5681.81 (SK-1-1 sample), 2281.71 to 4955.97 (SK-1-2 sample) and 2268.68 to 6422.57 (SK-2-2 sample). Furthermore, the LREEs show lower concentrations, resulting in an (La/Yb)N that is generally less than 0.1. A negative Eu anomaly and a positive Ce anomaly are observed in studied granitoids. Contents and patterns of REEs in the studied granite samples are similar to those reported by other authors with higher HREEs contents than LREEs (e.g., Hoskin and Schaltegger, 2003). Zircon Ti concentrations used to constrain its crystallization temperatures, and T is calculated by the revised Ti-in-zircon thermometry of Ferry and Watson (2007) (Supplementary Table). Calculated Ti-in-zircon temperatures for Sarnowsar intrusions (736° to 915 °C) are higher than those of Sarkhar (646° to 819 °C) and Bermani granitoids (653° to 861 °C). The △FMQ values (calculated by equation of Trail et al., 2011; Trail et al., 2012) for Sarnowsar range from -0.06 to 17.01. For Sarkhar and Bermani intrusions, the △FMQ values are in the range -4.43 to 4 and -8.53 to 0.07, respectively. These data indicating different magmatic conditions for productive (Sarnowsar) and barren (Sarkhar and Bermani) granitoids. Conclusion Defining the magma source and fertility of acidic to intermediate magmatism within the Cenozoic volcano-plutonic magmatic belts of Iran has immense scientific and mineral exploration significance. By using the zircon/whole rock partition coefficient in the Sangan mining area (Sarnowsar, Sarkhar and Bermani granitoids), we discuss the magma source and fertility of magmatism. The magmatism of Sangan mining district area is alkaline and classified as I-type granitoids, which have a direct genetic association with iron skarn mineralization in the area. The current results show that Sarnowsar granitoid was formed at a higher temperature (736° to 915 °C), lower negative Eu anomaly (with geometric mean 0.35 to 0.4), higher values of Ce4+/Ce3+ (25.56 to 718.62) ratios compared to Sarkhar and Bermani granitoids. Also, the Sarnowsar granitoid has lower Hf values (700 to 1199 ppm) and higher Zr/Hf (65 to 87) values, which shows that it formed in an earlier magmatic stage compared to Sarkhar and Bermani granitoids. The results of this research can be used for identifying productive Cenozoic intrusions in Iran that are related to porphyry and skarn mineralization systems.
Keywords
