Emitter: International Journal of Engineering Technology (Dec 2016)

Performance Analysis of Video Transmission Using Sequential Distortion Minimization Method for Digital Video Broadcasting Terrestrial

  • Novita Astin,
  • I Gede Puja Astawa,
  • Amang Sudarsono

DOI
https://doi.org/10.24003/emitter.v4i2.150
Journal volume & issue
Vol. 4, no. 2

Abstract

Read online

This paper presents about the transmission of Digital Video Broadcasting system with streaming video resolution 640x480 on different IQ rate and modulation. In the video transmission, distortion often occurs, so the received video has bad quality. Key frames selection algorithm is flexibel on a change of video, but on these methods, the temporal information of a video sequence is omitted. To minimize distortion between the original video and received video, we aimed at adding methodology using sequential distortion minimization algorithm. Its aim was to create a new video, better than original video without significant loss of content between the original video and received video, fixed sequentially. The reliability of video transmission was observed based on a constellation diagram, with the best result on IQ rate 2 Mhz and modulation 8 QAM. The best video transmission was also investigated using SEDIM (Sequential Distortion Minimization Method) and without SEDIM. The experimental result showed that the PSNR (Peak Signal to Noise Ratio) average of video transmission using SEDIM was an increase from 19,855 dB to 48,386 dB and SSIM (Structural Similarity) average increase 10,49%. The experimental results and comparison of proposed method obtained a good performance. USRP board was used as RF front-end on 2,2 GHz.

Keywords