Surgical planning for staple fixation of the first tarsometatarsal joint: An anatomic study

Abstract

First tarsometatarsal (TMT) arthrodesis is a common procedure utilized by foot and ankle surgeons for the management of a variety of first TMT pathology including hallux valgus and arthritis. The present study was undertaken to determine the average staple leg depth that allows for adequate purchase within the medial cuneiform and first metatarsal base at 2 different staple bridge lengths for dorsal compression across the 1st TMT joint. A cadaveric study was performed using 20 fresh-frozen below knee specimens. After TMT dissection was performed, drill holes were then created from dorsal to plantar and parallel to the first TMT joint at the distances utilized for 20 mm and 25 mm staple bridge lengths. The depths of each drill hole were measured and recorded. The mean medial cuneiform depth corresponding to a 20 mm and 25 mm staple bridge was 31.9 mm +/- 2.8 mm and 31.1 mm +/- 2.1 mm respectively (P-value = 0.38). The mean first metatarsal depth corresponding to a 20 mm and 25 mm staple bridge was 27.9 mm +/- 2.2 mm and 25.4 mm +/- 3.4 mm respectively (P-value = 0.04), showing statistical significance. Based on our anatomic data it is suggested that a 20 mm staple leg depth is consistently a safe depth when using 20×20 and 25×20 mm dorsal compression staples. However, further studies must be conducted to compare the amount of compression between the two respective staples.

Keywords

• 5