Combining Taguchi method and DEAR method for multi-objective optimization of grinding process

Abstract

In this paper, a study on multi-objective optimization of the cylindrical grinding process is presented. The experimental material used in this study is X12M steel. The two output parameters of the grinding process considered in this study are surface roughness and material removal rate (MRR). The cutting mode parameters including cutting speed, feed rate, and cutting depth have been selected as input parameters of the experimental process. Experimental matrix by Taguchi method has been used to design a matrix with 27 experiments. Analysis of experimental results by Pareto chart has determined the effect of input parameters on output parameters. The Data Envelopment Analysis-based Ranking (DEAR) method has been applied to determine the values of input parameters to simultaneously ensure the two criteria of minimum surface roughness and maximum MRR. Finally, the development direction for further studies has also been recommended in this study.

Keywords

• cylindrical grinding
• x12m steel
• surface roughness
• mrr
• multi-objective optimization
• taguchi
• dear